Explainer WCSNG · Backscatter & RFID sensing
How RFID Works, Component by Component
A passive UHF RFID tag has no battery and no radio transmitter. Instead, it reflects energy back to the reader. The reader sends out a continuous 915 MHz wave. The tag harvests enough of that wave to power a tiny chip. It answers by switching its antenna between two impedances, so the reflection carries its ID back to the reader. These 21 short chapters follow the signal through every block of that loop, each with an animated diagram.
Reader · transmit
Crystal Oscillator
Generates a stable reference frequency (~10–20 MHz) that everything else locks to.
PLL Frequency Synthesizer
Multiplies the reference up to exactly 915 MHz. Phase-locked loop keeps it dead-on.
Power Amplifier
Boosts the 915 MHz carrier from milliwatts to 1 Watt (+30 dBm).
Circulator
3-port ferrite device: TX→antenna, antenna→RX. Keeps transmitter from blasting the receiver.
Reader Antenna
Converts electrical signal to electromagnetic wave radiating into space.
ASK Modulator
Reader encodes commands by briefly dropping the CW power. PIE encoding.
Free space
Tag · power harvesting
Tag Antenna + Matching
Dipole or loop, conjugate-matched to the chip's complex input impedance.
Charge Pump (Dickson Rectifier)
Ladder of diode-connected MOSFETs + caps. Converts ±200 mV RF to 1.2V DC.
Shunt Regulator / Voltage Limiter
Clamps VDD below 1.8V when tag is too close to reader. Protects the chip.
Power-On Reset (POR)
Voltage comparator holds digital logic in reset until VDD is stable.
Tag · downlink
Envelope Detector
Peak detector on VDD rail. Reader drops power → VDD dips → that's a bit.
Ring Oscillator (Clock)
5–11 inverters in a loop. ~1.5 MHz. No crystal — drifts with voltage and temperature.
Tag · protocol engine
Gen2 State Machine
~5000–15000 gates. Parses commands, manages anti-collision slots, orchestrates response.
EEPROM / NVM Memory
96-bit EPC (writeable), 48-bit TID (factory-fused), user memory. This IS the tag's identity.
Anti-Collision (LFSR / Slot Counter)
Random number generator picks a slot so multiple tags don't talk at once.
FM0 / Miller Line Encoder
Converts data bits into a switching pattern. Every bit boundary toggles; a '0' also toggles mid-bit.
Tag · backscatter uplink
Reader · receive
IQ Mixer (Demodulator)
Multiplies received signal by carrier and 90°-shifted copy → I and Q baseband channels.
Phase Extraction
arctan(Q/I) = phase of the reflection: the number phase-based RFID sensing reads.
FM0 Decoder / Bit Recovery
Correlator finds the preamble, then decodes FM0 transitions back into EPC bits.
RFID research at WCSNG
These projects build on the backscatter link explained above to turn ordinary RFID tags into battery-free sensors: